About Transmet IS series is a simple installation of integrated dew point transmitter for measuring flammable gases or general moisture content, which is particularly designed for use in hazardous situations. Stainless steel package under, Transmet IS enclosure protection rating to IP66 (NEMA 4X) level. The transmitter's range is -100 ~ + 20 ° C dew point accuracy of 1 ° C dew point, the dew point is usually the limit transmitter can provide accuracy. Transmet IS fast response to the continuous measurement of the user in real time. Transmet IS through the set-up and calibration, you can install the factory and work immediately after a user receives no additional setup or calibration work. Highlights ATEX, FM & CSA certified check a wide range of range of -100 ~ + 20 ° C dew point superior accuracy ± 1.0 ° C rapid response maximum pressure 30 MPa (300 barg) rugged IP66 (NEMA 4) enclosure protection Technical Specifications Sensor thread 5/8 "UNF parallel Case Stainless Steel Ingress Protection IP66 (NEMA 4X) Power 10 ~ 28 V DC reverse polarity protection Output current: 0-20 mA or 4-20 mA analog selection, linear correspondence to ° C dew point Humidity range -100 ~ + 20 ° C dew point accuracy ± 1 ° C +20 ~ -59.9 ° C dew point ± 2 ° C -60 ~ -100 ° C ± 0.3 ° C dew point temperature resolution 0.1 ° C -80 ~ +20 ° C dew point 1 ° C -100 ~ -80 ° C dew point temperature of 0.1 ° C Operating Temperature -20 ~ + 60 ° C storage -40 ~ + 70 ° C maximum working pressure 30 MPa Flow 0-10 Nl / min gas flow rate 20m / sec1 (maximum) barrier selection system 1: Zener safety barrier (must be grounded) system 2: Isolated Barrier (no common ground) Option: sensor sampling sleeve, a display unit (Cermet II IS), power supply module also offers a variety of sampling systems